Puffco Peak Pro 3DXL

• Latest version (2026.07)
• 3DXL chamber holds 78% more
• 360° wall heating, no floor element
• Ready in about 20 seconds
• Around 40 dabs per charge
• Four presets from 254°C to 302°C
• App control in single degrees, 232-316°C
• USB-C and wireless Qi charging
• Five-slot glass water filtration

The Peak Pro 3DXL is the flagship e-rig from Puffco, the concentrate specialists who created the modern e-rig category with the original Peak. It is consistently rated among the best e-rigs on the market, and the reason is the 3DXL chamber paired with temperature control that holds steady through a whole draw.

This is a concentrate-only rig, so it does not work with dry herbs. It sits at the premium end of the category, and in exchange you get the 3DXL chamber as standard, the app platform with firmware updates, and a magnetic hard case in the box. If you dab daily and want repeatable results without a torch, this is the rig that makes that routine quick and simple.

The base stands 15.5 cm tall and weighs 376 g, with a metal core, stainless steel elements and a silicone outer body with decorative fluting that resists concentrate drips. With the Glass 2.0 water piece fitted, the assembled rig stands about 24 cm, so it sits comfortably on a table and can still be held in one hand.

The single button on the front does everything, with a light tap of vibration each time you press it. An LED ring at the base and lights under the glass show the heat setting, the battery state and error codes, so you always know what the rig is doing without reaching for your phone.

Four rapid clicks activate Stealth Mode, which switches all the lights off when you want no light show at all. The rig travels in the included magnetic hard case, which has a snap closure, moulded compartments for the cable and swabs, and a clip point.

The 3DXL chamber is the reason people choose this rig. Its heating coils sit in the side walls only, with no element in the floor. Think of the chamber as a bowl formed by heated side walls: warmth comes from the edges, never from below.

That layout matters in practice. During a draw the concentrate climbs the heated walls in thin layers; between draws it settles onto an unheated floor, so nothing scorches while you rest. The bowl is 23 mm deep against the standard chamber's 15 mm, giving 78% more capacity without a wider bore.

The extra depth is what lets the chamber handle big loads well. Dabs of 0.3 g to 0.5 g and above sit in the deeper bowl with far less concentrate pooling and far less residue left behind, which means less waste and a cap that stays cleaner. Puffco state the 3DXL produces around twice the vapour of the standard 3D chamber.

Fitting a 3DXL is also what unlocks the app's exclusive XL level of Vapor Control. A spare 3DXL chamber and the smaller 3D chamber are both available separately if you want a second chamber in rotation.

Several sensors inside the chamber feed a microprocessor that adjusts the heat continuously. The effect is much like a thermostat for the heating chamber: the rig holds the temperature you asked for, no matter how big the load is or how hard you pull.

Cheaper rigs work on voltage, so they push full power for a set time and overshoot at the start. Holding a true temperature is what keeps flavour clean right to the end of the draw.

Four presets cycle with a single click: Blue at 254°C, Green at 266°C, Red at 277°C and White at 302°C. Around 254°C to 266°C keeps delicate terpenes intact, while 277°C to 302°C extracts more material in a shorter cycle. Green is a sensible place to start.

Two extra modes hide behind click patterns. A double click during a running cycle triggers Boost, adding 15 seconds and about 10°C. Five clicks starts Intensity Mode, which Puffco designed for dry dabs with no water in the glass.

The included Peak Pro Glass 2.0 is borosilicate glass in a cone shape, heavier and sturdier than the previous generation at 96 g. Five laser-cut percolator slots at the base feed air into internal vortex grooves that cool the vapour on its way up.

The metal XL Joystick cap sits on top of the chamber and also serves as the airflow control, so there is no separate airflow knob to turn. Four intake holes steer air into the chamber corners and push concentrate onto the heated walls, and a spring returns the cap to the centre when you let go, much like a gaming controller.

The joystick also spins a finned terp pearl on its own, so there is no manual mixing. The stock mouthpiece points straight up, which means leaning over the rig a little. A lower travel glass or a replacement Glass 2.0 are available separately if you want a different profile.

The Puffco Connect app is where you find the advanced settings. It gives single-degree control across 232°C to 316°C, session lengths up to 2 minutes, up to 25 saved heat profiles, Vapor Control levels including XL, live chamber temperature, a dab counter, cleaning reminders and custom LED colours.

Firmware updates arrive through the app too, and they have added real features to rigs already in use. One update unlocked Vapor Control across existing Peak Pro rigs at no cost, so the device gains new features over time.

The rig works fully without your phone. All four presets, Boost, Intensity and Stealth run from the single button, and profiles you save get stored on the rig itself. One thing to know: a firmware update through the app is required before the 3DXL chamber will work, and Bluetooth needs re-pairing fairly often.

The app is on the Apple App Store and Google Play. On iPhone, Puffco recommends installing it through their Path Browser.

The concentrate goes on the bottom surface of the chamber, in the centre rather than against the walls. A rice-grain dab is the usual reference load, and the deeper bowl handles much larger amounts when you want them. The included loading tool does the job and also works as a scraper for reclaim.

A warm chamber makes loading far easier, because the concentrate melts straight in and does not smear on the sidewalls. You can add the Hot Knife (sold separately) for this, since its heated ceramic tip releases concentrate in about three seconds.

One button handles the whole session, and the vibration tells you when to draw. Charge it fully first, and remove the protective paper insert from inside the chamber and the film from under the glass.

1. Filling: Lift the glass off the base, then pour water through the mouthpiece to just above the percolator slots. Refit it by aligning the inlet hole with the chamber.
2. Loading: Place your concentrate in the centre of the chamber floor with the loading tool.
3. Powering on: Hold the button for three seconds and check the battery light: green for full, orange for half, red for low.
4. Choosing a temperature: Single-click through Blue, Green, Red and White, or pick a saved app profile.
5. Heating: Double-click to start. About 20 seconds later the rig flashes and vibrates twice.
6. Drawing: Inhale gently while rotating the joystick cap. A second double-click adds Boost for a stronger finish.
7. Finishing: The cycle ends by itself after its set duration, or you can end it early with a press and hold. The rig then goes to sleep on its own.
8. After the session: Swab the warm chamber with a cotton swab in gentle circles.

The Peak Pro 3DXL averages around 40 dabs per charge, which for most daily users means charging once a day, much like a phone. Higher temperatures and longer two-minute sessions draw more power than short low-temperature dabs, so the number moves with how you use it.

A full charge takes about two hours from the USB-C port at the rear of the base. The kit includes a USB-C to USB-C cable but no wall plug, so you supply your own 5 V/2 A adapter. Any Qi pad charges it wirelessly as well, and you can even top it up from a phone with reverse wireless charging.

The battery is sealed inside and not user-replaceable. The app has a battery preservation mode that caps charging at around 80% to reduce stress on the cell, and using the USB-C cable for everyday charging is the gentler routine.

If you do not have a spare wall plug, our USB-C Fast Charger (45W) (sold separately) covers the full two-hour charge at proper speed.

The habit that matters most takes ten seconds. Swab the chamber with a cotton swab in gentle circles while it is still warm after every session, and oil never gets the chance to bake onto the ceramic.

A deeper clean every 100 dabs or so keeps everything working and tasting its best, and the app will remind you. The glass soaks in 90%+ isopropyl for 20 minutes, then rinses with water and air-dries completely before it goes back on.

The chamber is handled differently. It soaks in 90%+ isopropyl for 20 minutes and then air-dries completely. It is never rinsed with water. For the base, clean the connection points and the air path with a swab dampened in isopropyl; never rinse or submerge it.

Keeping the gold connection pins clean is also what prevents the chamber-detection error, seen as red and white flashing. If it appears, tighten the chamber a quarter turn and clean the pins.

The Peak platform has the widest selection of custom glass tops in the e-rig market, made by independent artists and companies. Swapping is easy: lift the old piece off, align the inlet hole and press the new one on.

Glass is cross-compatible across Peak generations, and pieces bought six or more years ago still fit. Moving to a custom top changes the pull noticeably, and it also fixes the awkward neck position that the stock glass forces on you, because its mouthpiece points straight up.

The practical result is that your investment carries forward through glass upgrades. The base and chamber stay; the glass on top can change as often as you like.

The Peak is Puffco's entry-level e-rig, smaller and roughly half the price. It runs a smaller integrated 3D chamber, a simpler glass bubbler and one-button operation with nothing to configure, and it takes the same glass tops as the Pro.

The Peak Pro 3DXL gives you a deeper 23 mm chamber against 15 mm, with 78% more capacity. Temperature is set in single degrees through the app with up to 25 saved profiles, where the Peak runs four fixed presets with no customisation. The Pro also adds wireless Qi charging alongside USB-C, around 40 dabs per charge against 35, and a magnetic hard case in the box.

If you dab occasionally and want the simplest way to get started, the Peak does the job well. The Pro is clearly better for precise temperature settings and large dabs.

The Proxy is Puffco's portable, modular concentrate vape: a compact heater and chamber that drops into interchangeable glass bodies. It is genuinely pocketable, its carry case is excellent, and it suits casual concentrate users well.

The Peak Pro 3DXL is built for the full home rig experience instead. The 78% larger 3DXL chamber, five-slot water filtration in the Glass 2.0 and around twice the vapour of a standard 3D chamber all point at sessions at a table. Deep app control adds single-degree temperature setting, session lengths to two minutes and Vapor Control up to XL.

Choose the Proxy if you want pocket portability; choose the Peak Pro 3DXL if you dab at home every day.

Right now we offer a 25% discount on all accessories when you buy any vaporizer here at MagicVaporizers. Here is a guide to what is worth adding alongside the Peak Pro 3DXL.

USB-C Fast Charger (45W): The box has a cable but no wall plug, and this 45 W adapter is the missing piece for the two-hour full charge.

New Hot Knife: Melts concentrate straight into the centre of the bowl, so nothing smears on the chamber walls during loading.

Travel Glass: Lowers the assembled height for transport and gives you a more natural head position while inhaling.

3DXL Chamber: The chamber is the one true wear part in the system, and a second one means a cracked chamber never stops you from dabbing that evening.

3DXL Chamber - Black (Limited Edition): The same larger chamber in a black finish, for anyone building an Onyx or limited-edition rig.

3DXL Chamber - Plasma (Summer Edition): The same chamber in the Plasma colourway, a summer edition that is gone once it sells out.

3D Chamber: The shallower chamber conserves material on small dabs and keeps a second chamber in rotation while the other air-dries.

Peak Pro Link: Puts the Peak Pro's temperature control on a traditional glass rig you already own, replacing torch and timer.

Glass 2.0: Glass breaks, and a full-size replacement gets you back to water-filtered sessions the same day.

The Puffco Peak Pro 3DXL comes with a 2-year warranty on the electronic base and a 1-year warranty on the battery. All Puffco Peak Pro 3DXL vaporizers we sell are authentic Puffco products.