AirVape Legacy Pro 2

• Latest version (2026.07)
• Ready in about 15 seconds
• On-demand mode heats in 7 seconds
• Swappable 3200 mAh 18650 battery
• Precise control from 100°C to 240°C
• 24K gold-plated chamber, glass vapour path
• Magnetic screens snap in and out
• Herbs and concentrates, pad included

The Legacy Pro 2 sits at the top of AirVape's Legacy range, and it is built around one idea: a portable you can keep running for years. It is consistently rated among the best portables in its class, praised for its flavour and the sheer number of features packed in.

It suits daily users who want both quick single draws and longer timed sessions. The Legacy Pro 2 weighs 232 g, so you notice it in a pocket. That mass buys a full-size swappable battery, a proper colour screen and a chamber that lies flat on the table while you fill it.

The Legacy Pro 2 measures 119 × 52 × 21 mm, so it is slim and flat enough for jeans or a jacket. The body is wrapped in handmade cork with gold flakes embedded at random, which means no two look quite the same. The cork also insulates against heat and adds grip.

A hinged clamshell lid opens flat like a book. The vape sits stable on a table while you load, which is easier than balancing an upright vape in one hand.

Cork is a natural material, so small wrinkles or variations can appear over time. AirVape treats these as part of the hand-finished character. A large full-colour display sits on the front, showing battery level, set temperature, live temperature and the session countdown, and it dims itself when idle.

The Legacy Pro 2 uses hybrid heating. The 24K gold-plated chamber warms the herbs by direct contact, and hot air is pulled through at the same time. Gold spreads heat evenly across the chamber surface, which helps avoid the hot spots that make draws feel harsh.

Session mode reaches temperature in about 15 seconds and then holds it for 3, 5 or 10 minutes with a countdown on screen. This is the relaxed setting, good for sharing or for a longer sit-down.

On-demand mode is the other personality. Hold the power button, wait roughly 7 seconds for the vibration, then inhale. Heat stops the moment you let go, which leans the extraction more towards convection, saves battery and keeps each draw short and discreet.

Press both temperature buttons at the same time to switch between the two modes. A short buzz confirms the change.

The vapour route inside the Legacy Pro 2 is long and indirect on purpose. Air enters at the base, rises through holes around the edge of the chamber, passes through the screens and then travels down a removable borosilicate glass mouthpiece tube before a final bend into the ceramic mouthpiece.

That distance gives the vapour time to cool. Draw comfort is one of its strongest points, even at the higher herb settings. A silicone sleeve is included as a heat guard if your lips are sensitive.

The glass section and the ceramic mouthpiece keep the flavour clean, since the vapour touches no plastic on its way out. The first draws of a load carry the most flavour, and the taste turning toasty is your signal that the chamber is finished.

The stock mouthpiece is deliberately short to keep the vape compact. The optional Extra Long Mouthpiece adds more distance from the hot chamber and gives you more to hold on to.

Two buttons set the temperature in precise steps anywhere from 100°C to 240°C. There is no fixed preset list, so you land on the exact number you want and the screen shows both your target and the live reading as the heater climbs.

Around 180 to 185°C is the sweet spot for flavour and lighter compounds. Between 205 and 215°C the extraction is faster and pulls more from the load. A good general starting point is 190 to 200°C.

For herbs, stay at or below about 218°C. Above roughly 220°C the Legacy Pro 2 switches automatically into concentrate mode, and herbs can scorch at those settings.

The gold-plated chamber holds around 0.25 g of ground herbs, which suits a solo session or a small group. A medium grind and a light pack work best. Overpacking is what creates extra cleaning later.

Twisting the top cap counter-clockwise drops a disc into the chamber and cuts the usable volume by roughly 25%, taking it to about 0.2 g. That is the built-in answer for micro-dosing and single-person sessions.

The Legacy Pro 2 also handles concentrates. A stainless steel mesh pad is included in the box; place it in the chamber, add a small amount on top, and the vape switches to concentrate mode above 220°C on its own.

Filling the chamber by hand can be fiddly. Pre-filled dosing capsules (sold separately) remove that step entirely, and a MiniVac container keeps ground herbs sealed while you carry them.

Three buttons handle everything. There is no app, no Bluetooth and nothing to pair or update, so the vape works fully on its own.

1. Loading: Grind to a medium consistency, open the clamshell lid and fill the chamber with a light pack. Tamp gently with the included tool, then close the lid until the latch clicks.
2. Powering on: Click the power button three times. The colour screen wakes and shows your last temperature.
3. Setting temperature: Use the up and down buttons to reach your number. The display shows the temperature in °C or °F.
4. Choosing a mode: Press both temperature buttons together to switch between session and on-demand. A buzz confirms the change.
5. Heating: In session mode, wait about 15 seconds for the vibration. In on-demand mode, hold the power button for roughly 7 seconds until it buzzes.
6. Inhaling: Draw slowly and steadily. Long draws pull noticeably more than short ones.
7. Stirring: Halfway through, use the stir tool stored in the body to even out the load. Skip this step if you are using a capsule.
8. Finishing: Session mode ends itself when the countdown runs out, and a motion sensor shuts the vape down soon after it is left still. Open the lid and tip the used herbs into a jar.

The Legacy Pro 2 runs on a removable 3200 mAh 18650 battery that swaps out in seconds. Lift the small door beside the chamber, drop in a charged cell and carry on. Standard 18650 cells are easy to find, so the vape does not become disposable when the original cell ages.

Expect roughly 6 to 12 sessions per charge depending on mode and temperature, with on-demand drawing less power than session mode. A USB-C charge takes around three hours, and the port sits on the rear, so charging works best with the vape lying flat.

You can vape while it is plugged in. The box includes a USB-A to USB-C cable, and no wall adapter comes with it. Wireless charging is also supported, which is very rare among portables: set the vape on a wireless charging pad and it tops up without a cable. The pad itself is a separate purchase.

Carrying a second cell turns charging into a non-issue. The Eve 30P - 3000 mAh 18650 Battery is a good match built for steady high-drain power, and the Xtar X2 - Battery Charger fills two cells outside the vape so it stays available.

Cleaning was the weak point of the original Legacy Pro, and the V2 answers it directly. The whole vapour path cleans with one long brush included in the kit. A silicone grommet on the outside pulls back to reveal an access port sized for that brush, so you can reach past the bend near the mouthpiece.

The magnetic screens are the other change. They are twice the size of the previous design and snap in and out with your fingers, with no silicone seal to wrestle with.

A quick clean takes a couple of minutes: pop the screen out, wipe the chamber with a cotton bud and isopropyl alcohol, then brush the path. For a deeper clean, remove the glass mouthpiece tube and soak it in alcohol, then rinse and dry it.

Rising draw resistance is your cue that the screens need attention. New screens and a set of dosing capsules (both sold separately) keep maintenance short, since capsules reduce how much herb touches the chamber in the first place.

The Arizer Air Max is the flagship of Arizer's Air series, a session vape with an all-glass vapour path and its own replaceable 26650 battery. It runs longer on a single charge, needs less frequent cleaning, and includes a water pipe adapter in the box.

Ready in a fraction of the time, the Legacy Pro 2 heats in about 15 seconds against roughly a minute for the Air Max, and about 7 seconds in on-demand mode. The Air Max is session-only, so there is no way to heat just for a single draw. The Legacy Pro 2 also handles concentrates with the included mesh pad, while doing so in an Air Max voids its warranty.

Low-temperature flavour around 180 to 185°C and the option of quick single draws point towards the Legacy Pro 2. Clean simplicity and longer runtime per charge point towards the Air Max.

The Mighty+ is Storz & Bickel's long-running former flagship, still the reference point most premium session vapes are measured against. It brings a deep accessory ecosystem and a long track record for reliability.

Two heating modes in one vape is the clearest difference. The Legacy Pro 2 does timed sessions and 7-second on-demand draws, where the Mighty+ is a session vape. Both weigh about the same, 232 g against 242 g, but the Legacy Pro 2 is slimmer and flatter at 21 mm thick, and its 18650 cell swaps out by hand.

The two sit close together on flavour and draw comfort. If a battery you can change yourself, a full colour screen and concentrate support out of the box matter to you, the Legacy Pro 2 covers more ground.

Right now we offer a 25% discount on all accessories when you buy any vaporizer here at MagicVaporizers. Here is a guide to what pairs well with the Legacy Pro 2.

Dosing Capsules (6-pack): Pre-load six sessions at home and skip the messy chamber filling entirely. Our top-selling Legacy Pro 2 accessory.

Bamboo Case: Locks shut and keeps odours contained, so the vape travels without announcing itself.

Glass Bubbler + Silicone Adapter: Run the vapour through water to make settings above 220°C comfortable.

TightVac MiniVac: An airtight pocket container that keeps ground herbs sealed and odour-free between sessions.

Extra Long Mouthpiece: Adds distance from the hot chamber for cooler draws, and gives you more to hold on to than the short stock one.

Eve 30P - 3000 mAh 18650 Battery: A spare cell built for high-drain vaporizers; it delivers steady power from a full charge right to the end.

Xtar X2 - Battery Charger: A dual-bay charger with an LCD readout that fills two cells while the vape stays in use.

Concentrate Pad: A second mesh pad for waxes and oils, so concentrate use never waits on a clean one.

Screens (6-pack): Three mouthpiece screens and three airpath screens that snap in magnetically when airflow starts to tighten.

The AirVape Legacy Pro 2 comes with a 2-year warranty covering defects in materials and workmanship. All AirVape Legacy Pro 2 vaporizers we sell are authentic AirVape products.